Q&A ROUNDUP

FLex Waveguide Polisher

Sept. 21, 2020, 11:31 p.m.
Q
Hello, We are interesting in a polisher but would like to run DI water while polishing. Is this OK to use water with these polishers?
A
Depending upon the particular application, an individual polishing step may be processed either dry or with water. Water tends to provide better surface finish when used on the final step. Just a couple light sprays of water on the film is sufficient.
Was this helpful? 0 0

Proton™ Field and FTTX Polisher

Sept. 21, 2020, 4:48 p.m.
Q
What is included with the purchase of this unit? Does it polish SC, LC, FC both UPC and APC? Thanks.
A
Workholder fixtures (ie. for SC-UPC, SC-APC, FC-UPC, FC-APC, etc) are purchased as needed with the base Proton polisher. Please forward your specific connector requirements to sales@krelltech.com and we will generate a quotation for your application.
Was this helpful? 0 0

Radian™ Bare Fiber Polisher

Aug. 31, 2020, 10:22 a.m.
Q
Hello, Would it be possible to polish at 60° ? Maybe with a longer fiber holder ?
A
Yes. Adapters are available for both Radian and NOVA, that extend the polish angle to 60 degrees. We will directly email a quotation for both systems.
Was this helpful? 0 0

SpecPro™ Connector Polisher

Aug. 7, 2020, 5:34 p.m.
Q
hello, is there a part number or SKU # for the SpecPro bare fiber/connector polisher for ordering purposes
A
Yes. The part number for the SpecPro base polisher is "SP4L". Please note, this will require either a connector or bare fiber workholder fixture.
Was this helpful? 0 0

High Capacity UPC Connector Workholders

June 16, 2020, 9:03 p.m.
Q
Can this high capacity polishing fixture be used with the Scepter X2 polishing machine?
A
Yes. This Krell polishing fixture can be used with either the standard Scepter connector polisher, or the Scepter X2 polishing machine. See attached data sheet,
Was this helpful? 0 0