Is there a video I can watch on how to properly clean a connector using this CleanTouch product?

We do not have a video. However, the correct procedure is just to lightly touch the ferrule tip to the cleaning port and remove. Do not twist or wipe. No solvents are required. It is suggested to use each port only once. If you would like a sample, please contact sales@krelltech.com.

What is the drifference between a work holder and fixture?

Both terms are used in the polisher industry to describe the same device that holds connectors, termini, adapters, etc., and engage with a base polishing machine.

How do you maintain the height of the platen during spinning? Basically my concern is if the platen is wobbling or randomly going up and down, it will damage the fiber. Thanks!

Our rotating platen (in which polishing film is placed on a glass disk/rubber pad) lies directly upon the polisher baseplate. Both consist of aluminum that is ground to a high level flatness tolerance. Additionally, a quality control run-out measurement inspection(i.e. up/down movement) is perform

What is the smallest diameter fibre the Radian Machine is capable of polishing?

Radian supports a fiber outer diameter range from 80um to >3mm.

Can this unit also polish FC connectors?

Accessories are available to convert the fixture to support FC connectors.